f. Copying with Glob

We would like to modify each of the files in shell-lesson-data/creatures, but also save a version of the original files, naming the copies original-basilisk.dat and original-unicorn.dat. We can’t use:

$ cp *.dat original-*.dat

because that would expand to:

$ cp basilisk.dat minotaur.dat unicorn.dat original-*.dat

This wouldn’t back up our files, instead we get an error:

cp: target `original-*.dat' is not a directory

This problem arises when cp receives more than two inputs. When this happens, it expects the last input to be a directory where it can copy all the files it was passed. Since there is no directory named original-*.dat in the creatures directory we get an error.

Instead, we can use a loop:

$ for filename in *.dat
> do
>     cp $filename original-$filename
> done

This loop runs the cp command once for each filename. The first time, when $filename expands to basilisk.dat, the shell executes:

cp basilisk.dat original-basilisk.dat

The second time, the command is:

cp minotaur.dat original-minotaur.dat

The third and last time, the command is:

cp unicorn.dat original-unicorn.dat

Since the cp command does not normally produce any output, it’s hard to check that the loop is doing the correct thing. However, we learned earlier how to print strings using echo, and we can modify the loop to use echo to print our commands without actually executing them. As such we can check what commands would be run in the unmodified loop.

The following diagram shows what happens when the modified loop is executed, and demonstrates how the judicious use of echo is a good debugging technique.